So, as I use the inflate brush, I notice more faces are being made as you smooth it out, however, when I try to inflate th...

Question

So, as I use the inflate brush, I notice more faces are being made as you smooth it out, however, when I try to inflate that boxed like area, new faces don't get added. I'm so confused. Any suggestions?

Answer 1 · 2015-09-16T18:21:03Z

Kent Trammell replied September 16, 2015 6:21pm

What is your detail mode set to: Subdivide Collapse, Collapse, or Subdivide Edges?

Answer 2 · 2015-10-19T22:32:04Z

p

replied October 19, 2015 10:32pm

Me too — I have the same problem I believe. I'm using Subdivide Collapse.

Answer 3 · 2015-10-19T22:38:36Z

p

replied October 19, 2015 10:38pm

I've discovered the problem. I had enable Dynotop but then, accidentally turned it off again using Undo without realising.