Cant finish this chapter until someone rates my wheel.
I'm sure the community can help you with grading. Can you share the link to your submission?
Thanks Phil. Here is the link
https://sketchfab.com/3d-models/rimandtire-c9a8b4f3e6aa4fcb8cb65c2a557d3167
This looks good. Did you submit it to the exercises page? I didn’t see it over there.
I really thought I did. Perhaps thats why its not getting graded. I will check again.
I have a pending exercise and when I click on that in my dashboard it takes me to the published 3d model of my rim, and on the bottom of the page it says:
"Hang tight while your submission is being graded! In the meantime, help out by grading some other submissions. "
So I dunno.
Interesting. I don't see it at all on the exercise page. On the whole, I'd say it looks good. You have quite a bit of dense, overlapping geometry on the tire, something you would want to fix if this were part of a larger project. But for an Intro to Modeling course, it's sufficient to move on I think. The big thing here is understanding the radial array.
You might try to contact support or resubmit? But if you just want to move on, I think there is a button somewhere on your profile where you can "mark as complete" any of the courses. It would be cheating yourself if you hadn't done the work, but you have.
I see where you can move along if its a sub unit or not a submission unit but it appears on the submission lessons there is nothing to move me along. The last exercise that i submitted was no issue.
Bummer, tech support troubles at work, and now at play. I cant win.
I resubmitted the wheel, Now I see 2 submissions from me, but no one else can. That is a bummer.
