Hey Everyone, I've just finished working on the model of the Sci Fi Crate. I have added some extras such as the handle and a few extra extrusions and indents. what do you think??
This was a fun beginner project to start learning!
Hey All,Β
I have just finished working through building the Hard Drive in the Mesh Modeling course. I have also added a few ports and a power button on the back.
Hey All,
Here's my attempt at making my version of a cup & saucer from the introduction to the sub division surface section of the mesh modeling course. Im sure it could be better and the mesh could be improved but overall not too bad of an attempt?
Just gone through making the Cookie lesson and here is the results. I will definitely have to go through this a few more time before I can do this one by myself, might be a while before I can do this without the video!!!
