Hi, how are you ?
Does anyone know what is my best option to connect my edges here please ? I was going to K and select edges to F. Also could have done a vertical bisect.
What do you think ?
Hi David,
If I understand it correctly, what you want to do is:
You might want to do that with the other (almost parallel) Edges as well.
F just makes an Edge between the Vertices, that doesn't 'interact' with the rest of the Mesh. J connects the Vertices 'through' the Mesh...
That's a bit of a clumsy explanation, but try it out, you'll see the difference.
I would then draw the “support edges” over the entire mesh, for example, but I'm sure you're aware of that too
OH, I see!
I didn't read that picture very well...
I'd take part of a Circle and Add a larger Plane (in Edit Mode) and Delete its Face and Subdivide it to match the Circle and then Bridge Edge Loops and extend outwards and inwards, something like this:
You can Add Edge Loops where needed and give it some thickness (it is sometimes easier to start 2 Dimensional and Extrude afterwards...)
Thank you for the diversity of your answers ! I have the choice. Since it's for a wall with not so many details, I will go with light topology I think. Thank you again !
