So every time I copy paste of even slightly move the Arms they decide to freak out and go in every direction before arriving to the keyframe and sometimes even the keyframe gets changed even when it's copy pasted or flipped. It's annoying cause everything else is fine this has never happened before and everything else that's copy pasted is fine it's just the arms.
Do you have IK setup on the arms? If yes you need to make sure that the chain length is set right. 2 I believe. If no IK then what constraints do you have set on them.
I think you are describing some discontinuty,
The orientation might be the same, but the angles are rotating one or more revolutions too many times to get there.
There's many ways this can happen, but copy and pasting values from one spot to another can be one of them.
Try selecting the curves (in the left hand side of the GE), then in the Channel menu, try the Discontinuity Filter
Thanks so much for the help you three I do appreciate it. I was thankfully able to fix the issue I'm very thankful.
