Node Setup for Blender 3.5 please for : Parametric Building: Gradient Fix

Hello @jonlampel#4986 @Spikey#8850 , can you help with a full node set up snapshot for the Gradient Fix on 3.5 please as I have looked through question section and can't see full node snapshot but just a section. If there is a description it is ok as well. I am totally new to Geometry Nodes and found this a bit confusing. Thanks!

  • cameramannz1986 replied

    not to sure this might help you https://www.youtube.com/watch?v=t_1ufg-nm3o

    1 love
  • Martin Bergwerf replied
    Solution

    Hi Mr. Onur,

    It is simply a matter of swapping out one Node:

    Swapping.png

    Or, even better, use 3.2 or 3.3LTS for this; a model made in 3.5 might give an error when trying to open it in 3.3.

    2 loves
  • Onur Nidayi(fhyio123) replied

    Thank you Mr.Martin !,


  • Onur Nidayi(fhyio123) replied

    Thanks Camera :)