When I mirror the planes, the mirrored side isn’t on schematic

Is there any way i can fix this or will i have to do both of them individually? I don’t know if the fact that we mirrored here will be a factor later so i am hesitate to do them separately.

  • spikeyxxx replied

    Did you accidentally disable this:

    Mirror.png

    ?

    The Mirror Modifier will be applied before joining the speakers with the console, so you could model one side and duplicate it to the other side manually, but why bother...

  • Kendrick Granville(KreativeKendrick) replied
    Hey, I don’t know and I’m not sure where to find Mirror.png if i did disable it. Yeah, it would be less efficient doing them separately but i can’t along them properly while in mirror mode because if i move one over the other is off schematic so duplicating probably the best move.
  • spikeyxxx replied

    KreativeKendrick the site has some quirks since moving to Mavenseed. Mirror.png is just an image and it does show up for me, but it isn't important, because now I understand what you mean (I think). The Mirror Modifier mirrors around the Object's Origin. You probably don't have it at X = 0.

    The following instructions assume that your Console is modelled at the center of the World.

    To place the Object's Origin back at the center, you can press SHIFT+S > Cursor to World Origin:

    Cursor.png

    Then:

    Origin.png

    That should give the desired result:

    Symmetry.png


    • 🍪
    1 love
  • Kendrick Granville(KreativeKendrick) replied

    Ahhhh I see, my origin is at the world center but that center is inbetween my buttons and the Dpad, the tutorial has it in the middle of the screen lol. I will just try to place it there in the middle and then when I’m done Shift+S it back to the world origin.

    *edit* Welp that didn’t work either haha ill just duplicate and place because i want to move forward.

    *edit 2* Okay so i figured out i can just place a 3D cursor in the middle of the screen, select the object and then set object origin to 3D Cursor and it should be about right. I’m so proud of myself LOL

    • Nice!
    • 💡Well done
    1 love